iP380 IP Phone
BLF icons and Message Light indication IP Phone

  • 8 BLF icons (Busy extensions
    Indication) on LCD
  • Select and display FXO Line status
    via 8 BLF as Key Phone Set (KTS)
  • Message light indication (Ring, DND,
    No Answer call, voice mail)
  • LCD: 2 x 20 digits with 8 icons BLF
    display
  • Remote DTMF or Ring control Relay
    contacts to Open/Close
  • IPV6 and IPv4 Dual Stack
    simultaneously
  • 3 Lines Register to three SIP Servers
  • Auto Provision
  • Wall-mount installation without
    additional brackets

8 BLF icons on LCD display

Information

iP380 provides BLF (Busy Lines/extensions status) with 8 icons
on LCD display. It shows user name and phone number of this
extension. Each iP380 can configure your favor or frequent
call extension or desire FXO Line. By showing busy extension
status via flashing BLF icons, it helps your office work increase
efficiency.

Navigation Keys

iP380 provides Navigation Key (Up, Down, Left, Right) to Configure/View from LCD
display along with OK (confirm change) and C (cancel and go back to previous page).


 

8 BLF icons work as Key Telephone Set (KTS)

iP380 can configures FXO Lines to BLF icons and work as KTS (Key Telephone Set).
Each FXO Line busy status can be seen from BLF icons and can be selected desire
FXO Line to dial.

 

Remote DTMF to control Relay Open/Close

Built-in Normal Open (NO) and Normal Close (NC) software control Relay, iP380 can
work as Door Phone and drive Door Open control circuit by activating NO or NC
Relay. Or, install at NOC (Network Operation Center) to control Server RESET or
Power ON/OFF remotely. Or, Install at residential house for Home Automation control
remotely.

 

Incoming Ring signal to Control Relay contacts Open/Close

In a noisy environment, You may not be able to hear incoming ring from iP380. It
supports software controlled NC and NO Relay to activate external amplifier with desire
sound and flash light to indicate there is incoming call at this phone set. Activate Siren
and Strobe Light when incoming call arrives.

 

Provision is easier than before

Provision server software with Windows and Linux version are supported to manage,
configure and firmware download remotely to LP803. It is definitely an intelligent
communication gadget.

 

Wide range of message light View Angle

iP380 provides a Message Light Indication with 360 degree wide range view angle. You
may see this light ON in a distance when you have Missed Call, incoming Ring, DND and
Voice Mail.

 

Desktop view angle and Wall mount

iP380 can be installed on Desktop and Wall Mounted without additional brackets. The
view angle on Desktop position can be adjusted from 30 to 75 degrees. Pull up handle
to adjust desktop view angle. iP380 can install on wall by folding bracket and hang it
with two screws.

 

Rich Telephony Features

iP380 is compatible with market available IPv4 and IPv6 SIP server or IP-PBX server
(such as Welltech’s IP-PBX 6200 series and Asterisk IP-PBX) with a variety of
telephony features which are similar to legend digital PBX features and operational
behaviors. iP380 provides flexible talking facility to switch among Handset, Hand free
Phone and Headset ear phone and microphone for heavy phone call user. A smart and
intelligent design is waiting for you to use it at both IPv6 and IPv4 address network
world.

 

Management IP Phone is easier than before

iP380 support HTTP provision feature via MAC address. An unique MAC address profile
at each iP380 IP phone was configured before installation. Those MAC addresses
profiles were created at HTTP, FTP and TFTP server. It allows system manager to
change each iP380 IP Phone configuration and firmware upgrade remotely.

 

Specification

  • Interface:
    • Ethernet port (RJ-45, 10/100Base-T)
      • 1-WAN port connect to Ethernet Switch
      • 1-LAN port connect to Computer
      • PoE (IEEE 802.3af ) at WAN port : iP380A only
    • Earphone/Microphone Jack (3.5mm) for Headset:
      • Normal Open(NO), Normal Close(NC) Relay terminal:
        LAN port free two pairs wire.
    • Handset Jack (RJ-10)
    • DC 12V/1A power input Jack
    • LCD Display:
      • Display Format: 20 Characters x 2 lines, icons x 8 pcs
      • View Size: 99(W) x 24 (H) mm
      • LCD Type: STN
    • LCD Language: English and Portugal.
  • IP Network connection
    • WAN: DHCP, PPPoE and Static IP
    • Dynamic DNS (DDNS)
    • VLAN on both WAN and LAN
    • VID (802.1Q/TAG): 3 to 4094
    • User Priority (802.1P): 0 to 7
    • Voice QoS Support
    • SIP QoS Support
    • DNS Client
    • VPN: VPN and L2TP
    • NTP Time Setting with Daylight Saving time
    • IPv4 (RFC 791), IPV6(RFC 2460)
    • IPv6 Auto Configuration (RFC 4862),
    • Static IPv6 Address, IPv6 in IPv4 Tunnel.
    • LAN: Bridge and Router(DHCP Server)
    • DMZ and MAC Clone Setting
    • MAC Address (IEEE 802.3)
    • TCP/UDP (RFC 793/768)
    • RTP/RTCP (RFC 1889/1890)
    • IPV4 ICMP (RFC 792), IPV6 ICMP(RFC 4443)
    • TFTP Client
    • HTTP/HTTPS Server
    • Support IPV4 only, IPV6 only or dual stack mode
  • SIP Protocol :
    • RFC3261 compliance
    • Support up-to 3 SIP Register Accounts (IPv4 and IPv6 are selectable)
    • Configure SIP port and RTP port
    • SIP UDP Protocol
    • Support SIP compact Form
    • SIP Session Timer (RFC 4028)
    • MD5 Digest Authentication
    • Reliability of provisional responses PRACK (RFC3262)
    • Early/Delay media support
    • Offer/answer (RFC3264)
    • Message Waiting Indication (RFC3842)
    • Event Notification (RFC3265)
    • REFER (RFC3515)
    • Support DNS SRV to locate SIP Server (RFC 3263)
    • Support STUN NAT Traversal
    • Support “rport” parameter (RFC 3581)
    • Configure user agent content
    • Send Flash Event: DTMF, SIP INFO, SIP INFO(digit)
    • Configure Encryption Type and key
  • Audio Codec :
    • G.711 A-law/μ-law, G.723
    • G.729A, G.726 (ADPCM), GSM
    • Silence Suppression
    • VAD/CNG
    • Automatic Gain Control
    • DTMF: In-band, Out of Band, RFC2833, SIP INFO.
    • Adaptive/Configurable Jitter Buffer up to 96 packets
    • Acoustic Echo Cancellation
    • Full-Duplex Speaker Phone
    • Volume Adjustment (Receiver and transmitter)
  • PREFERENCE:
    • Customized Idle Text
    • Clock, Daylight Saving, Call-timer
    • Call History of Missed, Received and Dialed
    • Dialing Plan
    • Digit Manipulation
    • Selectable Call Progress Tone
    • Support Personal Music Ring
    • Auto Answer Mode
    • Support Auto Priority (Auto Switch) Calling
    • Support Specified Line Calling
  • Call Features :
    • BLF x 8 icons with Name and Number
    • Caller ID display or inhibit
    • Voice Mail with Indication
    • Speed Dialing
    • Phone Book x 140 records
    • Flexible Dial Plan Setting – Drop Prefix and Replace Rule
    • Call Waiting/Switching between Calls
    • Call Forward (Busy, Unconditional, No Answer)
    • Hotline function
    • Alarm Time Setting
    • Auto Answer set up
    • Ring Timeout
    • Do not disturb
    • Call Hold
    • Call Mute
    • Call Transfer
    • Configure Tone: Dial Tone, Ring back Tone, Busy Tone, Congestion
      Tone, Ring Tone and Call Waiting Tone.
    • Music-on-hold support (via IPPBX or local)
    • Conferencing (3-way conference over phone)
    • Call Pickup (configure Code)
    • Call Park/Retrieve (via IPPBX)
    • Voice Broadcasting (via IPPBX)
    • Redialing/pre-dialing
    • Support Peer to Peer Dialing
    • Reject Anonymous call
  • Software control Relay features :
    • Configure to Normal Open(NO) or Normal Close(NC) Relay
    • Activate by NO or NC
    • Remote RFC2833 DTMF activate Relay contacts Open/Close
    • Incoming Ring to activate Relay contacts Open/Close.
    • Relay contact specification: 1A at 250V
  • MANAGEMENT :
    • Multilanguage Web User Interface
    • Administrative Telnet CLI Login
    • 3 Levels of User Access Right with Password protection
    • LCD Administration Login
    • Provides System Status
    • Diagnostics via syslog with different log type
    • LAN port bandwidth limitation
    • Configuration Backup/Restore
    • Reset to Default
    • Auto Provision via TFTP, HTTP and FTP with Schedule
    • Auto update firmware via TFTP, HTTP and FTP with Schedule
    • Firmware upgrade via webpage
    • Disable WAN port management
    • Configure WEB Login port (default is 9999)
    • TR-069 (Option)
  • Environmental :
    • Physical Dimension: 190(W) × 90(D) × 210(H) mm
    • Weight: 1.1kg (One unit with packing)
    • Single pack dimension: 225x195x115 mm
    • Operating Temp. & Humidity
      • Temp.: 0°C~45°C (32°F~113°F)
      • Humidity: 10%~90% relative humidity, non-condensing
    • Power Adaptor:
      • INPUT: AC100V~240V, 50/60Hz
      • OUTPUT: DC 12V, 1.0A
    • Power Consumption of PoE : 5.5 Watts
  • Approvals:
    • CE, FCC, LVD and RoHS
  • Country of origin:
    • Made in Taiwan
  • Packing Accessories
    • iP389 IP Phone x 1 pcs
    • Handset x 1 pcs
    • AC to DC12V Power adaptor x 1 pcs
    • Screw to fix foot plate x 1 pcs
    • CD User Manual
  • Warranty
    • One year
 

Ordering Information

  iP380 iP380A
PoE NO YES
IPv6/IPv4 YES YES
Handset and Hand-Free YES YES
Headset and Ear phone YES YES
Wall Mount YES YES
Delivery Status NOW NOW
 

Copyright © 2012. WELLTECH TECHNOLOGY CO., LTD. All Rights Reserved.