WellGate 2844
8-Port FXO and FXS mixed SIP IP Gateway

 

WellGate 2844 Front View

WellGate 2844 Rear View

 

  • Dual IP Stack : IPv6 and IPv4 Simultaneously
  • Support up to 16 SIP Trunks to register
  • Enhance existing PABX to VoIP Call
  • 8-port mixed FXO and FXS gateway by hardware modules
  • Flexible Routes Plan, Dial Plan, Digit Manipulation
  • Redundant Firmware Image
 

Introduction

Information

WellGate 2844 is a 8-port mixed FXO and FXS gateway with SIP
protocol IP device which allows to connect either up to 8 Lines of
analog PSTN telephone line, 8-port FXO (or extensions of PABX),
or connect up to 8 Lines analog telephone set, 8-port FXS (or,
analog trunk line of conventional PABX) to make or receive VoIP
call over Internet or VPN network. This device is not only suitable
for conventional PABX to enable VoIP call without changing existing
cabling, dial plan, and extension number, but also work with IP-PBX
and SIP Server directly.


To select up to 16 SIP TRUNK Accounts

WellGate 2844 is appropriate to use 16 VoIP SIP Trunk or IP Centrex service or IP-PBX
within offices and remote branch offices. One of 16 SIP Servers (or ITSP Service provider
or alternative IP-PBX ) can be configured freely at each line ( FXO port or FXS port ) to make
or receive IP Call. It provides 16 service platforms according to your dial number or routes plan.


IPv6 VoIP Gateway is ready to Market

IPv6 address was developed for years, however, it was not practical to our life up to now.
More and more electronic devices are able to link to IP Network(for instance, Internet of
Things, IoT) this makes existing IPv4 address supply are in shortage to global market.
Meanwhile, the emerging countries are not able to increase IPv4 address supply due to
strong market demand on broadband services. WellGate 2844 is an SIP based FXO plus
FXS gateway which was built-in both IPv6 and IPv4 IP address. Whenever you are ready
to deploy IPv6 network, or reserve the future expansion to Pv6 from existing IPv4 address,
WellGate 2844 is ready to grow up with you. Both IPv6 and IPv4 addresses are working
simultaneously at Voice IP Call. Its flexibility of both IPv6 and IPv4 accept and interwork
both addresses on today and tomorrow whenever you need.


Flexible Dial plan and Route Plan Features

WellGate 2844 provides flexible Dial Plan between FXO, FXS and SIP IP Trunk (SIP Soft Switch
or IP-PBX). Dial Plan is to configure in what condition the digits can be sent out to/from IP
network. The dialing inter-digit time before dialing is configurable to meet local PSTN line or
PBX’s extension line. Dial Rule is able to detect the prefix code and maximum digits reached
and then dial automatically. The Digit Manipulation (DM) allows you to configure matched
prefix code, digits length, start and stop digit position to be replaced digits as well.

Route Plan is to configure the incoming and outgoing call routes which you want this call to go
out or allow to income. For instance, IP incoming call may reach to one FXO or FXS port with
Priority or Cyclic access. You can also configure IP incoming call by Matched prefix digits,
matched dialing number to FXO/FXS line and matched digit length. For FXO/FXS outgoing call
to SIP IP routes, the hunting type supports Priority or Cyclic or Simultaneously to select
which SIP trunk (SIP Proxy Server, or IP-PBX ) to go. FXO/FXS outgoing call routes also
support by Matched prefix digits, Matched outgoing SIP Trunk number and Matched digit
length. Both directions support No Answer time out and Backup Routes.


Upgrade existing PABX to enable VoIP call

WellGate 2844 is a SIP IP device to connect with existing PABX and enable to make or receive
VoIP call without affecting existing cabling, extension number or dial behaviors. It is an easy
and quick way to upgrade existing PABX to VoIP calls. No need to expand your PABX’s extension
lines and analog trunk lines. FXO lines can be connected with extensions of PABX in order to
talk with remote office via IP.


 

Specification

  • Interface :
    • Ethernet port (RJ-45, 10/100 base-T)
    • 1-WAN port, connect to IP Network
    • 1-LAN port connect to PC with NAT
    • Support Bridge, NAT and Gateway mode
    • Telephony port connect to PSTN line (RJ-11 x 8 pcs)
    • DC +12V power input Jack
    • LED Indicator for System, SIP, and FXO status
  • IP Network connection :
    • IPv4 (RFC 791) and IPv6 Simultaneously
    • IPv6 Auto Configuration (RFC 4862)
    • IPv6 Only, IPv4 Only or dual stack
    • MAC Address (IEEE 802.3)
    • MAC Clone Setting
    • Vendor Class ID
    • IP/ICMP/ARP/RARP/SNTP
    • Static IP
    • DHCP Client (RFC 2131), WAN port
    • DHCP Server, LAN port
    • NAT Server (RFC 1631)
    • PPPoE Client
    • DDNS (DynDNS )
    • DNS Client
    • Firewall
    • URL Filter
    • IP Filter
    • MAC Address Filter
    • Application program Filter
    • Port Filter
    • Port Forwarding (TCP, UDP or both)
    • Bandwidth Control (Download and Upload),
      Maximum Bandwidth priority setting
    • UPnP Server at LAN port
    • Behind NAT, use DMZ for NAT traversal
    • SNTP with time zone and Daylight Saving
    • TCP/UDP (RFC 793/768)
    • RTP/RTCP (RFC 1889/1890)
    • IPV4 ICMP (RFC 792),
    • TFTP Client
    • VoIP VLAN Support 802.1Q, 802.1P
    • VLAN ID Range : 2 to 4094
    • VLAN Priority : 0 to 7 (Highest Priority)
    • QoS : DiffServ (RFC 2475), TOS (RFC791, 1394)
  • SIP Protocol :
    • RFC3261 compliance
    • Support up-to 16 SIP Trunk to Register
    • SIP UDP Protocol
    • Support SIP compact Form
    • Support SIP HOLD Type: Send Only, 0.0.0.0 or inactive
    • SIP Session Timer (RFC 4028)
    • SIP Session Refresher: UAC or UAS
    • SIP Encryption
    • MD5 Digest Authentication (RFC2069/RFC2617)
    • Reliability of provision response PRACK (RFC3262)
    • Early/Delay Media support
    • Offer/Answer (RFC3264)
    • Message Waiting Indication (RFC3842)
    • Event Notification (RFC3265)
    • REFER (RFC3515)
    • Support Outbound Proxy
    • Support Primary and Backup SIP Server
    • Support STUN NAT Traversal
    • Support “rport” parameter (RFC 3581)
    • Configure SIP local Port
    • SIP QoS Type: DiffServe or QoS
    • Accept Proxy Only : YES or NO
  • Audio Codec :
    • G.711 A-law/μ-law, G.729A, GSMFR, G.723.1(6.3K, 5.3K)
    • Select voice codec priority: According to Local or Remote
    • Voice Payload size (ms) configuration
    • Silence Suppression
    • VAD/CNG
    • LEC : Line Echo Canceller
    • Max Echo Tail Length (G.168): 32, 64 and 128ms
    • Packet Loss Compensation
    • Automatic Gain Control
    • In-band/out of band DTMF (RFC4733, RFC2833 / SIP INFO)
    • Adaptive/Configurable Jitter Buffer
    • G.168 Acoustic Echo Cancellation
    • Configure RTP basic Port
    • RTP QoS Type : DiffServ or TOS
    • Phone Book (50 records) for peer to peer calls
    • Dialing Plan with drop, replace, Insert dialing digits
    • Select First digit and Inter digit timeout duration (Sec)
    • Selectable Call Progress Tone
    • Support Specified Line Calling
  • Call Features :
    • Support Peer to Peer Dialing
    • Up to 4-port FXS connects to analog phone set or analog trunk of PBX
    • Caller ID generates DTMF (before/after 1st ring) and FSK (before 1st ring ),
      ETSI and Bellcore
    • DTMF Caller ID start and stop BIT configurable
    • Current Drop generation to FXO analog devices
    • Disconnect tone recognition to release FXO port
    • Tone Generation: Ring Back, Dial, Busy, call waiting, ROH, Warning, Holding,
      Stutter dial tone and disconnect tone
    • Configure Tone Frequency, Cadence, Level and Cycle
    • Select Tone specification by Country name List
    • Global Country Based Tone Specification
    • NAT Traversal support STUN, UPNP and Behind NAT
    • Out-Band DTMF : RFC2833 and SIP Info
    • RFC2833 Payload type : 101 or 96
    • DTMF send out ON and OFF Time configure
    • DTMF incoming recognition Minimum ON and OFF time
    • DTMF Relay Volume configuration
    • T.38 FAX Volume configuration
    • Flash Time transmit via SIP Info (Enable or Disable)
    • Message Waiting Indication (Stutter Tone Notice)
    • Block Anonymous Call
    • Call Hold
    • Call Transfer
  • FXO/FXS Line Configuration :
    • Activate or deactivate
    • Line ID
    • Line Phone number
    • Polarity Reversal generation for call establish and Billing.
    • Current drop generation to release line
    • Incoming call Handle: Hotline or 2 stage dialing
    • HOT Line to desired phone number
    • Play voice file to incoming call
    • Repeat playing voice file counts
    • Generate FLASH TIME to PSTN network
    • T.38 or FAX Relay Type
    • Incoming and outgoing volume in dB configurable
    • Dialing Answer Delay time to establish call path
    • Answer PSTN incoming call after how many ring cycles
    • Caller ID generation mode by Country selection
    • VoIP dial to FXO/PSTN Line: 1 stage dialing and 2 stage dialing
    • Outgoing SIP Caller ID Selection
    • Support 16 SIP Trunk
    • Accept desired SIP Proxy incoming calls Only (Avoid hacker’s call)
  • Flexible Routing Plan :
    • Prefix Match and Length
    • Priority Ring
    • Cyclic Ring
    • Simultaneous Ring
    • Programmable Hunting Cycle
    • Backup Routes with Digit Manipulation
    • Default Routes
  • Flexible Dial Plans :
    • Retrieve transfer call from 3rd party by dial Code (default: *#)
    • Inter digit time out setting
    • First digit dial out delay time setting
    • End of dial keypad number
    • Dial Rule : Match dial Prefix and Maximum digits length ( 1-15 )
    • Phone Book can be Exported or Imported
  • Digit Manipulation (Drop and Replace Rule) :
    • FXO DM Group
    • VoIP DM Group
      DM 1 Group
      DM 2 Group
      DM 3 Group
      DM 4 Group
    • Matched Prefix
    • Matched digit length
    • Replace digit start position
    • Replace digit stop position
    • Replace number
  • FXS Analog 2-wire interface :
    • Flash Time Detection: range from 80 to 800 ms
    • ON-HOOK Voltage -48Vdc
    • Configure Ring Cadence, Frequency and Voltage
    • Support Polarity reversal to start Billing
    • Service Up to 1 Kilo-meter distance to analog telephone set
    • Generate Current Drop Time (Open Loop Disconnect time)
  • FXO Analog 2-wire interface :
    • Incoming Ring frequency recognition range: 10 to 70 Hz
    • Incoming Ring ON time recognition range: 0 to 8000ms
    • Incoming Ring OFF time recognition range: 0 to 8000ms
    • Incoming Ring Level recognition range: 10 to 95Vrms
    • Flash Time Detection: range from 80 to 800 ms
    • Configure Ring Cadence, Frequency and Voltage
  • MANAGEMENT :
    • Administrative Telnet CLI and HTTP, HTTPS
    • HTTP provision through MAC address
    • Multilingual Web User Interface
    • 3 Levels of User Access Authority with Password protection with
      different Web Language (Administrator, Supervisor and User)
    • HTTP/HTTPS Service Access limitation from WAN port
    • Configure Service ports at HTTP, HTTPS and Telnet Services
    • Phone Debug Module: Device Control, Call Control, DB, Verbose
    • SIP Debug Module: Register, Call, SIP Message, Others
    • SNTP Debug Module
    • Device Debug Module
    • DSP Debug
    • Provide 8 Debug Levels:
      Emergency
      Alert
      Critical
      Error
      Warning
      Notice
      Information
      Debug
    • Provides System Status Logs
    • Connect to external SYSLOG Server
    • Status display: Network, Line, SIP Trunk status
    • Diagnostics (debug through Syslog Event Notice)
    • Debug in real time by Telnet
    • Auto Provision via HTTP Server
    • SNMP V2/Trap
    • Configuration Backup/Restore
    • Dual Firmware Image Backup
  • Environmental :
    • Physical Dimension: 44(w) x 4.5(h) x 11(d) CM.
    • Weight: 2.3kg (One unit with packing)
    • Operating Temp. & Humidity
      • Temp.: 0°C~45°C (32°F~113°F)
      • Humidity: 10%~90% relative humidity, non-condensing
    • Maximum Power Consumption: 17 Watts (1.5A at 12Vdc)
    • Power Adaptor:
      • INPUT: AC100V~240V, 50/60Hz
      • OUTPUT: DC 12V, 3A
  • Approvals :
    • CE, FCC (Part 15, Class B), LVD and RoHS
  • Country of origin :
    • Made in Taiwan
  • Packing Accessories
    • WellGate 2808 main unit          x 1 pcs
    • AC to DC+12V/3A Power adaptor    x 1 pcs
    • Rack Mount bracket                        x 2 pcs
  • Warranty
    • One year

 


 

Copyright © 2015. WELLTECH TECHNOLOGY CO., LTD. All Rights Reserved.